10-31-2013 11:33 PM - edited 03-07-2019 04:22 PM
Hi all,
I have 6504e with 2 Etherchannels (2x1Gbps links in each), active and standby, BGP over each towards ISP.
Need to make etherchannel up ONLY when both members are up, to make etherchannel always have a capacity of 2Gbps.
Any idea?
Solved! Go to Solution.
11-01-2013 02:56 AM
This is supported for LACP Etherchannels.
This feature is called Minimum-Links
It allows you to configure the minimum number of member ports that must be in the link-up state and bundled in the EtherChannel for the port channel interface to transition to the link-up state.
int po1
port-channel min-links x (X is you value)
So in your instance it should be
int po1
port-channel min-links 2
That way if 1 fails, you do not have a minimum of 2, and the port channel will go down
This seems to be only available with LACP
11-01-2013 02:56 AM
This is supported for LACP Etherchannels.
This feature is called Minimum-Links
It allows you to configure the minimum number of member ports that must be in the link-up state and bundled in the EtherChannel for the port channel interface to transition to the link-up state.
int po1
port-channel min-links x (X is you value)
So in your instance it should be
int po1
port-channel min-links 2
That way if 1 fails, you do not have a minimum of 2, and the port channel will go down
This seems to be only available with LACP
11-03-2013 06:06 AM
Thanks a lot!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide