9300 selective QinQ

[delenni]

Hello,

I am setting up a POC for a migration. Looking for a good solution I found selective QinQ but it seems this is only supported on the Catalyst 4500 series.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/54sg/configuration/guide/config/tunnel.html

Does someone know if that feature is also planned for the 9300 series or another method that does the same.

Thanks in advance

[Mark Malone]

Hi
haven't checked this as not running fuji anywhere but says its available in 16.8.1 on C9300 , in section Software Features in Cisco IOS XE Fuji 16.8.1a

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-8/release_notes/ol-16-8-9300.html