ACI Leaf Interface status

[snarayanaraju]

Hello All - I am looking for a CLI command that can list out the free Interfaces in the ACI Leaf Switches.

"show interface status mod 1" command only shows the whether the interface is in "connected / not connected" status. 

But i am also looking for addition details, whether the interface is in "Discovery" or associated to an EPG, which we can easily find it over GUI by hovering over the interface in GUI. Do we have any CLI command to achieve this. Thanks for helping

[inderdeeps]

@snarayanaraju : From GUI you can check that "leaf 101 show interfaces"

[snarayanaraju]

Hello @inderdeeps - I am looking for a CLI command so that i can execute from the APIC. I have close to 40 switches.  The screen shot of the GUI i have attached here. Here you can see the Usage: discovery.

I am trying to find what is the CLI command to find the same.

[inderdeeps]

@snarayanaraju : check here

https://community.cisco.com/t5/data-center-documents/cisco-aci-cli-commands-quot-cheat-sheet-quot/ta-p/3145799