Discuss Catalyst brand switches with peers and experts.
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Hi,   I was reading that the 3650 and 3850 switches are capable to serve as a Wireless Controller. My questions are:   1. Will the Wireless Controller be the full functional one or will it be limited? (Something similar to the Mobility Express)   2. ...

ejdrijin1 by Beginner
  • 3 replies
  • 0 Helpful votes

HELLO Guys I need your point of view about how can I run the this scenarioMy IP Phone (Brand name: Polycom) should get IP from our Internet Service Provider DHCP server. In order to do that the RJ45 cable from ISP switch (Cisco ASR 1000 x) connected ...

Hi all,I changed the baud rate for the console to 115200bps to speed up an IOS transfer through xmodem but cannot reset it back to the default 9600.Tried "set BAUD 9600" & "unset BAUD" seperately under switch: prompt but with no luck.Any help is much...

%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/6: Power given, but Power Controller does not report Power Good we are getting this error after we upgrade our ios from 12.2(55)SE to 152-2.E9 on the 2960s ( WS-C2960S-48LPS-L) sw...

Tkna by Beginner
  • 1 replies
  • 0 Helpful votes

Hi all, Looking for some advice on port security & mac address learning. Essentially we are looking to lock down connections on a particular VLAN running on our Cisco SX350 switch. I have toyed around with ACL which seem to work but are little sensit...

Hi there!I know it is discontinued/obsolete, but is there a way to get the lastest firmware? ** But i'm not 100% sure mine is older than the most current one: System object id: version: 00.03.00Software version: 1....

dev_intro by Beginner
  • 2 replies
  • 0 Helpful votes

Hello, I have a C2900 series router deployed and we're having issues with the "IP Input" process slowly using more and more of the CPU which ends up causing problems with the phone system here. I found this other thread: https://community.cisco.com/t...

mdonarumo by Beginner
  • 6 replies
  • 0 Helpful votes

dear all, please need you attention i have 2960 switch and connected with router with UTP distance is approximately 60 to 70 meter before it was working fine now i try to ping from l2 switch to router i facing drops and the switch seems like hanging ...