03-20-2017 05:10 PM - edited 03-08-2019 09:50 AM
I'm looking for ways to make editing ACL on my 3560-x Catalyst switches a lot easier. It's about 200+ lines. I think using Object Network Groups similar to ASA firewalls will be helpful.
I found this link but I don't think it's supported on Catalyst:
Any recommendations?
Solved! Go to Solution.
03-20-2017 08:47 PM
Object group feature is not supported on 3560 and 3750 switches. Please refer
https://supportforums.cisco.com/discussion/11119341/object-group-c3560-c3750-switches
03-20-2017 05:27 PM
Hi Marc
Yes you can use object-group in Switches and Routers like we do in ASA, to be honest not sure if all the switches support object-groups but you can try with the following config, the sintaxis is different than the firewalls.
Please let me prepare an example.
03-20-2017 05:42 PM
Example:
object-group ip port HTTP-PORT <-- object group for services
eq 80
object-group ip address SOURCE
host-info 172.17.2.5 <--- For a host /32
172.17.10.0 255.255.255.0 <--- network
ip access-list extended OUTBOUND-TRAFFIC
permit tcp addrgroup SOURCE any portgroup HTTP-PORT
The command addrgroup is used for the data groups like SOURCE and the portgroup is used for TCP/UDP ports.
I have used object-groups with Vlan ACL (VACL), if you are going to use object-group keep monitoring the CPU in order to verify if it is increased.
Please rate the comment if it is useful
:-)
03-20-2017 08:47 PM
Object group feature is not supported on 3560 and 3750 switches. Please refer
https://supportforums.cisco.com/discussion/11119341/object-group-c3560-c3750-switches
03-21-2017 11:20 AM
Thanks for confirming. This is also what I thought.
Any similar commands I can use on switches? My objective is trying to prevent so many lines on my ACL and make it easier to read.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide