Hey guys i need some help!
I am trying to set up my first switch. I am using the catalyst 2950 for learning on.
The network im on right now (the one with internet) has the following settings.
10.22.227.???
255.255.255.0
10.28.43.254
The one i am learning on i connect to it by going to 192.168.0.1 this will allow me into it using the Cisco Network Assistant.
I have a laptop on port 1 using Vlan1 and i have Desktop on port 24 with vlan 1 and i have a cable from our 10.22.227 network pluged into port 23
I am able to see the computers and i can share files on it. What i dont understand being a noob is why i dont have any internet on ether computer.
I have setup up port 23 as a switch.
It seams like to me i would have to give the switch a ip address a subnet mask a default gatway and a dns of the 10.22.227 network on port 23.
Can some one throw some light on the subject and point me in a good direction?
