Switching

Hi guys,A question that pertains to the 3750 : regarding unused interfaces or even shutdown interfaces is there any buffer allocated / reserved for such interfaces ?If I recall correctly, independently from the queue-set settings, each queue of an in...

Hi,Can we configured err-disable recovery interval per interface basis on cisco switch?May requirement is to configure err-disable recovery interval 15 min for few interfaces and 10 min for rest of the all interfaces of switch.I have configured port ...

Hello all,We have some cbs3120, running cbs31x0-universal-mz.122-50.SE3. I was looking for an IOS that supports ssh. Can't find anything, at least when I look at the supported features on the cisco site. The following url http://www.cisco.com/c/en/us...

Hi All,Have my hands on some new 5548UPs and looking for an stable image. It has 5.2.1.N1.6 as default, and it looks like we are up to version 7 code now.Can anyone advise on reliability of newer code?I did read the Minimum Recommended Code here but ...

Hi,I'm trying to understand the counter Rx-No-Pkt-Buff on module WS-X4548-GB-RJ45. We have a Supervisor Engine IV in this WS-C4506 chassis.I know this card has 6 portgroups in which members share 1Gbps throughput.I'm seeing inpunt errors on 2 interfa...

Hi,Is it possible to configure etherchannels between a layer 3 3560 switch and layer 2 2960-S switch stack?Any feedback would be greatly appreciated.

Hi,I have a query on Native vlan. Here is the topology Router 1 (e0/0) ------ (f0/1)SW1 (f0/2) ------ (f0/2) SW2 (f0/1) ------(e0/0) Router 2 Necessary configuration on the devices Router 1int e0/0.100encapsulation dot1Q 100ip address 10.0.0.1 255.25...

I have this configuration:int g0  ip address 1.1.1.1 255.255.255.0  nameif inside  security-level 100int g1  ip address 2.2.2.2 255.255.255.0  nameif outside  security-level 0int g2  ip address 3.3.3.3 255.255.255.0  nameif DMZ  security-level 50rout...

We have very simple configurations on our switches (small offices on an MPLS WAN link) that come to our HQ office for Internet access.  Our switches are all 3560X switches running 12.2(58)SE2 - IP-BASE CRYPTO.My question are these. 1.  Some switches ...

Hello,   any suggestions why the following ACL will not apply?   access-list 100 permit udp any host 192.168.155.18 eq domain access-list 100 permit tcp any host 192.168.155.18 eq domain access-list 100 permit tcp any host 192.168.155.18 establishe...

I saw this issue at work and I'm trying to duplicate it on my home lab... I'm a little confused on if I should use an access list, route map, or something else. From the point of view of Host C1 or C2, if packets going to Internet, I would want it to...