Aironet 1400 Ethernet

[Alizuno04]

Hello all,

Help please!

The led "uplink activity" in the cisco aironet 1400 -power injector lr- is off. I have checked coaxial and connectors, they are ok. I can not access the bridge by ethernet or telnet. I have reseted the bridge also, but the signal keep off. Is it a software/hardware problem?

Thanks

[Amit Singh]

If you trun the AP backwards, what lights do you see. There are three lights down at the bottom and there is a sequence in which they blink. Please keep an eye on the blinking LED's.

http://www.cisco.com/en/US/docs/wireless/bridge/1400/12.2_15_JA/configuration/guide/p15trb.html

http://www.cisco.com/en/US/docs/wireless/bridge/1400/installation/guide/higch6.html

I had the same problem and I upgraded the IOS on the bridges to the latest one and that did the trick. If it doesnot then its a hardware replacement.

HTH,

-as

[Alizuno04]

Hello Amit Singh,

Thank you!

The bridge is on my desk now. Only the -Installed led- is blinking.

I have made complete reset of the bridge. Before and after the reset I can not access the bridge (ethernet or telnet), how can I upgrade the IOS on the bridge?

Regards,