Aruba-2930F-24G-4SFP ( Layer 3)

[Dhikra Marghli]

Hello

i have a switch Aruba-2930F-24G-4SFP ( Layer 3)  But i have a problem about configuration CLI in HP

1) example in Cisco :

interface  ethernet  1 link with switch layer 2 ( DLINK)

switch trunk enpasulation dot1Q

switchport mode trunk

how i can configure this CLI  in switch layer 3  HP 2930F:  traduction to HP 

thanks in advance i a answer ASAB

2) 

[Dhikra Marghli]

I need some one help me about configuration switch Aruba-2930F-24G-4SFP 

i wait some one answer for my question 

[Reza Sharifi]

For Aruba config, go to this link and ask the question:

https://community.arubanetworks.com/t5/2930M/ct-p/2930M

HTH

[Dhikra Marghli]

please can you help because this forum don't answer me quicly and i need forum cisco help me

thanks in advance

[Georg Pauwen]

Hello,

I think that, other than on Cisco switches, the Aruba 2930 switches do not have the concept of explicit access and trunk ports as such. Below is a sample for a trunk port on the Aruba:

interface 24
tagged vlan 2-1001

This would make the port a trunk with the native Vlan being the default Vlan (1), and all other Vlans being allowed...