Assigning IP address to VLANs in SGE2010P

[jeff.ewing]

Hi.  Recently purchased 5 SGE2010P 48-port switches to replace older L2 switches.  I have 4 switches in single stack and one as a standalone.  Both the stack and standalone will connect to at least 1 Dell 2724 switch.  Both the stack and the standalone Cisco are in Layer 3 mode.

I have created several VLans on the Cisco switches, and am trying to assign an IP address to the VLan, but cannot seem to figure out the web gui.  Each time I try to use Systems > System Management > IP Addressing > IP Interface, then click Add, it simply changes the existing IP of the management interface.  So, I'm not sure how to go about assigning an IP Address to an Vlan. 

Your help is greatly appreciated.

Thanks

Jeff.

[amikat]

Hi Jeff,

How are you doing? If still not succeeded can you please return to switch CLI and issue the "sh ip d r" command and post the output. Also as a quick check can you please assign one of your Vlan 22 host static IP address and DG and try to ping both Vlan 22 and Vlan 1 interfaces. Also as you are running L3 mode can you please try without Option 82 enabled.

Best regards,

Antonin