07-16-2014 06:20 AM - edited 03-07-2019 08:04 PM
Hi,
I want to question in relation to the command "authentication mac-move permit".
This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches?
(used Wired 802.1x.)
When not authenticated to move the terminal to other switches, it went well You can use this command.
Thanks.
Solved! Go to Solution.
07-16-2014 03:06 PM
Hey,
Regarding your question:
This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches? - You are correct, mac move is allowed only on a single switch.
HTH.
Regards,
RS.
07-16-2014 03:06 PM
Hey,
Regarding your question:
This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches? - You are correct, mac move is allowed only on a single switch.
HTH.
Regards,
RS.
07-18-2014 12:50 AM
Hi,rajeevsh
thank you.
It's does not lead to another reason is likely.
(hmmm)
I will investigate again.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide