Hi Community,
I try to build my own ZTP workflow which needs to get a SNMP trap from a new switch after the switch got it's initial config via AutoInstall process.
I simply added the trap receiver to the network-confg and also added a "reload" a the end of the config.
With a WS-C2960C-8PC-L this works fine. Here is the part of my network-confg:
....
do write
!
do reload
!
end
So far so good.
But a test with a WS-C2960L-16TS-LL my workflow fails because this switchtype ignores the blank line after "do relaod" and stops with the "Proceed with reload? [confirm]" prompt.
Does anyone have any idea however I can get the switch to reload?
Why is there a different behaviour between this two switchtypes? Because of the SmartInstall function of the C2960L?
Thanks!
Sebastian