cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1428
Views
0
Helpful
2
Replies

Banner not showing in Cisco Multi-Layered Switch

utkarshahuja007
Level 1
Level 1

Hey, I have configured a simple banner in Cisco Multi-Layer switch Model- 3650 but when I reload the switch the banner is not showing. I checked in show running-configuration and it is present in both startup and running configuration but when I restart the system it only shows the default banner.

2 Replies 2

Hello,

 

which version of Packet Tracer are you using ? I just tested in version 8.1 (the latest), and the banner stays in the config even after reloading:

 

3650#conf t

3650(config)#banner motd ^C

Authorized Persons Only

^C

3650(config)#end

3650#wr

3650#copy run start

3650#reload

Hello

How are you connecting to the switch - reverse telnet or console?

 

 


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul