Best way to LAG Catalyst 9500 to a SG350xg

[redgasgiant]

I've been experimenting with connecting the "core" 2 stackwised 9500(which supports Pagp and LACP)  to the "edge" SG350(which supports just LACP?). 

The LAG on the 9500 consists of 2 25gb ports 1/0/1 and 2/0/1  and the LAG on the SG350 is 2 10gb ports XG3 and XG4

I have the LAG set to LACP on both sides, (ACTIVE mode on the 9500 and it's just a 'enable LACP" checkbox on the SG350)

Is that the best way? Should I be using PAGP or some other different mode on the switches? 

[Flavio Miranda]

Hi

 The best way on this case is the way it works. You said you have :

"I have the LAG set to LACP on both sides, (ACTIVE mode on the 9500 and it's just a 'enable LACP" checkbox on the SG350)"

Does it works? If does, then this is the best way. If not, then, it is not.

The way I would probably config

SG350

 
switchxxxxxx(config-if)# channel-group 1 mode on

9500

 
switchxxxxxx(config-if)# channel-group 1 mode on

[MHM Cisco World · Accepted solution]

Is that the best way? Yes this is best way

Should I be using PAGP or some other different mode on the switches? No need lacp better than pagp