09-05-2012 03:56 AM - edited 03-07-2019 08:42 AM
Hi,
I am using cisco 1841 LAN router, I need to block MAC address i have applied the command access-list 1102 deny 0000.0000.0000.0000 mac address..... but it does not work
Can anyone suggest...
Thanks,
Jeevan.
Solved! Go to Solution.
09-06-2012 06:10 AM
Hi,
post dir flash: output.
Regards.
Alain.
Don't forget to rate helpful posts.
09-06-2012 07:18 AM
Hi,
That comand is not working
Please check the IOS and version as mentioned in the above mail.
Thanks
Jeevan
09-06-2012 07:28 AM
I forgot the slash at the end: dir flash:/
anyway you should be able to dowload the correct PDLM for bittorent on Cisco site http://www.cisco.com/pcgi-bin/tablebuild.pl/pdlm if you are a registered customer and tell your router to use it with the command:
ip nbar pdlm "flash:/xxxxxx"
Regards.
Alain
Don't forget to rate helpful posts.
09-06-2012 07:49 AM
Hi,
I have done that and result as below
c1841-ipbase-mz.124-1c.bin
sdmconfig-18xx.cfg
es.tar
common.tar
home.shtml
home.tar
vlan.dat
i could not see any pdlm however this is a live router can i insert into it after the download.
Thanks,
Jeevan.
09-06-2012 08:02 AM
Hi,
yes you can and no need for reload.
Regards.
Alain
Don't forget to rate helpful posts.
09-06-2012 08:39 AM
Hi,
Can you tell me after match protocol rtp & rtsp and rtcp also online streaming videos are not getting blocked..
Thanks,
Jeevan.
09-07-2012 03:06 AM
Hi,
Can you update for the above as the real time streaming videos are not getting blocked.
Thanks,
Jeevan.
09-07-2012 04:10 AM
Hi,
Maybe you could also drop matching the mime-type
http://routing-bits.com/2009/02/15/using-nbar-to-match-web-traffic/
Regards.
Alain
Don't forget to rate helpful posts.
09-10-2012 10:23 AM
Hi,
I have restricted internet for some users using TCP/IP in my organisation.
I need to permit particular site in cisco router for access to restricted users, but instead i am able to browse that site not able to ping it.
I have permitted the IP which is showing in nslookup but still no luck, i have checked source code where i could not find the correct IP address
termview.apmterminals.com is the site
Thanks in advance,
Jeevan.
09-10-2012 10:29 AM
Hi,
that would be great for other users on this forum if you could at least tell us if the previous problems you had are solved or not and rate the correct answers that helped solve the problem.
It should be great also to start a new topic maybe because now we are far from blocking MAC addresses.
Regards.
Alain
Don't forget to rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide