10-20-2009 09:37 AM - edited 03-06-2019 08:12 AM
Hey guys,
I'm not well versed with this model and here's my problem. I already had an IOS in bootflash, but as I entered the new one and gave my 4507R-E a "boot system bootflash:NameOfIOS" command....it completely ignored and autobooted on the first IOS it found....The old one.
I ended up deleting and squeezing the old one so as to get what I wanted but, I would've enjoyed keeping the old one too.
Can you tell me what I'm doin' wrong, and how to go about doin'it right the nex time!?
Thanx,
WANimal
10-20-2009 09:50 AM
The command is boot: boot system flash slot0: If in slot 0.
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/hardware/configuration/notes/OL_2788.html
And from rommon:
http://www.cisco.com/en/US/products/hw/routers/ps5199/products_tech_note09186a0080094012.shtml
10-20-2009 10:27 AM
Usually from the factory the config register is 0x2101 which means it will load the first one it sees in bootflash . Change the register to 0x2102 then use "boot system flash bootflash:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide