Bridge VLANs

[RICHARD MESSINGER]

I have the need to translate VLAN Numbers between two areas of a customers network.  I have an MS250 in the middle. I have VLAN 8 coming in on a trunk port and I need to have it go out on a vlan trunk as VLAN 2352. what I thought I could do is have a port defined as Access VLAN 8 and have it looped to another port defined as Access VLAN 2352 and then away it would go on any Trunked interface that had VLAN2352 defined.

Is this possible

[Flavio Miranda]

Did you do this same question here?

There is a feature for vlan translation but not for Meraki as far as I know

switchport vlan mapping 1649 755 

https://community.cisco.com/t5/switching/meraki-switch-configuration-question/td-p/5209053

[Joseph W. Doherty]

I'm unfamiliar with the Meraki devices, but on a Cisco Catalyst switch, you can bridge two VLAN using access ports, as you propose.  (On a Catalyst, CDP will complain about the ports being in different VLANs and PVST/MST might be problematic, if enabled.)