11-30-2021 03:58 AM
Hello,
After a mistake when upgrading the IOS on my C4510R+E, the standby supervisor booted into ROMMON, but the supervisor booted like normal. I consoled into the standby, copied the new IOS from usb to the flash and booted, but it rebooted the whole stack. Is there a way to boot only one of the switches? I know you can reload only one switch, but can you do the same when just using the boot command?
Thanks!
11-30-2021 04:52 AM - edited 11-30-2021 04:55 AM
Hi,
you wrote "Is there a way to boot only one of the switches" so i guess you meant one from the modules?
hw-module module <module number> reset
11-30-2021 05:10 AM - edited 11-30-2021 05:10 AM
Thank you for the reply.
Can this be done from ROMMON or is there a similar command in ROMMON that will only boot the standby and not reboot the active supervisor as well?
Sorry I should have worded the original question better.
11-30-2021 07:37 AM - edited 11-30-2021 07:46 AM
Before you make any changes please take a look at the following link so you know how to Perform a Software Upgrade:
Before reloading the standby supervisor engine,
make sure you wait long enough to ensure that all
configuration synchronization changes have completed.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide