c7200p series routers on gns3

[saifbinhasan1]

I am new to gns3.I am trying to configure c7200p-adventerprisek9-mz124-20.T ios based router.But i found it is different than c7200 series router.what is NPE-G2 for this platform.And when i open the console it shows that ios is loading and nothing happens after that.Please some one help me out of this..

[julijime]

Hi saifbinhasan1,

This forum might not be the best for your query, however the IOS that you're using is for an NPE-G2 which is a routing engine supported on 7200 VXR routers and that cannot be emulated on gns3.

In this case you would need to use an IOS without the prefix "c7200p-" in the software image filename.

If you encounter further issues with with your setup we would suggest using the gns3 forum as they can provide detailed assistance regarding the gns3 software.

https://community.gns3.com/welcome

HTH

Julio

[Ganesh Hariharan]

Hello,

Agree Julio, But you can give a try trying different ios for other router. As 7200 series ios should work and load properly. 

Hope that Helps..

-GI