C9300-NM-4G for Catalyst 9300 - Routed ports/Dot1q

[YHam]

Hello all,

I'm trying to find out if each individual port on C9300-NM-4G module is a routed port and can have sub-interface with dot1q (Vlan tag) enabled?

I have been searching online but didn't find any document that answer the questions. I assume they are uplink ports so should support layer-3 and sub-interfaces etc but want to confirm so don't get surprised later.

Regards

[Reza Sharifi]

Hi,

The ports can be used as routed ports but sub-interfaces are not supported. You can use vlans with SVIs instead.

HTH

[YHam]

Hi Reza,

Thank you for the reply. Just to clarify, can each port be part of different vlan?

Can you share the official source of this information?

Thanks again

regards

[Reza Sharifi]

Hi,

Yes, each port can be in a different vlan. Functionality wise, there is no different between these ports and other port on the switch except in most cases these ports are used for uplinks. 

HTH