c9300 switch ping command usage
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2021 07:05 PM
I have used the IOS ping command for years. Very useful. A question though - can it be configured to send one ping per second? I can specify how many pings to send and the timeout, but i cant see where to set a delay between each ping. It sends as fast as it can.
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2021 10:59 PM
Perhaps delay can be influenced when using the Timeout option.
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2021 11:52 PM
Unfortunately not. Timeout just affects how long to wait for a reply. It doesnt affect the rate at which pings are sent
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2021 01:30 AM
- You are probably right, I was assuming that timeout might then affect the sending rate too.
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-16-2024 12:48 AM
Hello,
Also from the web dashboard of the appliance via the left menu :
Troubleshooting > Ping and Trace Route
More confortable
--Yoann
