01-13-2012 12:43 AM - edited 03-07-2019 04:19 AM
hi:
i would like to know if i can use "show ip protocol"to see if router is running load balance?
i.e below is the "show ip protocol"output
Routing Protocol is "eigrp 10 "
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default networks flagged in outgoing updates
Default networks accepted from incoming updates
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 10
Automatic network summarization is in effect
Automatic address summarization:
4.0.0.0/8 for FastEthernet0/0, FastEthernet1/0
Summarizing with metric 128256
Maximum path: 4
Routing for Networks:
0.0.0.0
Routing Information Sources:
Gateway Distance Last Update
1.1.1.2 90 920639
2.2.2.2 90 920639
Distance: internal 90 external 170
can i find any information about load balance here???
thanks
Solved! Go to Solution.
01-13-2012 12:53 AM
Hi,
The only information this output tells you is that you're running EIGRP and that the maximum path on which it could load-balance is 4 and that the variance is 1 so no unequal-cost load-balancing is possible.
Now you need the output of sh ip route to see if there were 2 paths or up to 4 in this case(default) with same metric that were installed to load-balance on these links.
Regards.
Alain
01-13-2012 12:53 AM
Hi,
The only information this output tells you is that you're running EIGRP and that the maximum path on which it could load-balance is 4 and that the variance is 1 so no unequal-cost load-balancing is possible.
Now you need the output of sh ip route to see if there were 2 paths or up to 4 in this case(default) with same metric that were installed to load-balance on these links.
Regards.
Alain
01-13-2012 05:36 PM
thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide