Can't access PIX 501 after switch from dsl to cable

[jblomstedt]

Hi--

I have two small offices and recently switched from dsl to cable internet. the two pix501 f/w units worked fine on dsl, but for the life of me I cannot even access the units now from the inside as I was able to do before when on dsl signal. I know I need to change the configuration from PPPoe to DHCP, but I can't get access to do it.

Any suggestions?

I believe I have 6.2 software, but I'm not sure. The Inside address is 10.8.6.1 now.

thanks--jb

[jblomstedt]

Jorge--

Are you still there?

Please write back and tell me what I can do with this Pix to get it going.

Is there anyone else with an idea?

thanks,

Jeffrey