cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
477
Views
0
Helpful
2
Replies

can't type after interrupting boot from flash

zipple
Level 1
Level 1

Hello, I have a catalyst 9300 that I wish to factory reset. I interrupted boot from flash and got to the "switch:" prompt. I tried to type in commands but couldn't.. The only key that the switch reacted to until now is ctrl+pause (which entered a new line in the session). I'm using HP zbook that is connected to the switch with RJ45 to DB9 console cable and a COM to USB adapter. I already tried to switch terminal applications, USB ports and cables. I also checked, and I can type in the terminal when I let the switch fully boot. Did someone had this problem and know the solution. I would appriciate it.

2 Replies 2

marce1000
VIP
VIP

 

  - Have a sanity check of the terminal infrastructure you are using  by trying to connect to another switch with it (e.g.) , 

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

balaji.bandi
Hall of Fame
Hall of Fame

that odd : switch:  ( can you able to type set ) that also not possible.

check the below settings if you using putty or simuilar :

balajibandi_0-1677059317315.png

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Review Cisco Networking for a $25 gift card