Cannot ping to Cisco.com from the PC in the topology

[ulvi95]

Dear Community!

I try to learn basics of Cisco Packet Tracer. I have tried to complete this: The Tutorial , but in the final, I cannot ping the Cisco.com. I provide the ZIP file with PKT file. What is the problem?

[Martin L]

Edit: Problem was with Cloud PT device having wrong ethernet6 settings and then Cable settings.

then, see if Wireless Router gets IP by going to Wireless Router, Status tab, IP release, then IP renew, then Refresh.

Regards, ML
**Please Rate All Helpful Responses **

[Martin L]

Update: Problem was with Cloud PT device having wrong ethernet6 settings and then Cable settings.
so, the issue was Wireless Router was not getting IP from Cisco Server.
adding this reply to make sure you read it again

Regards, ML
**Please Rate All Helpful Responses **

[ulvi95]

So how should I set configurations exactly? I tried to change, but unsuccessful.

[luis_cordova]

Hi @ulvi95 

You just have to change the cloud interface, from Ethernet6 to FastEthernet8

For this, click on the green triangle:

Then click on the cloud and choose the FastEthernet8 interface:

After being like this, the ping and connectivity will be successful.

Regards

Remember to mark the correct answers as solved, because that helps other users with similar doubts.

[Martin L]

3 ways to fix issue of Cloud PT picked FastEthernet8 instead Ethernet6.
to change it now, existing Cloud settings, you must start with Ethernet6 settings, change connection from DSL to Cable. then on Cable settings, remove link Coax7 to Fast Ethernet 8, and add Coax7 to Ethernet link.  just like pictures in pdf document you provided except there is no FE8;
Or Delete Cloud PT only and drag new one, set up as pictures in pdf document
Or change link to FastEthernet8 as Luis_C showed you

Regards, ML
**Please Rate All Helpful Responses **