09-03-2018 08:49 PM - edited 03-08-2019 04:04 PM
Hi there, I have a need to apply tracking to a route map to one of our SVI interfaces on a 4507 chassis - however it doesnt seem to be possible? is this a licensing issue? I can set ip next hop, ip default next hop and ip default next hop verify-availability - but I cannot add a track statement to the end of any of these commands.
We are currently using entservices license on the chassis:
ABN_CORE_4507#sh license in-use
License Store: Primary License Storage
StoreIndex: 0 Feature: entservices Version: 1.0
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
License Store: Dynamic License Storage
Running version
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500es8-UNIVERSALK9-M), Version 03.07.01.E RELEASE SOFTWARE (fc3)
Solved! Go to Solution.
09-03-2018 11:52 PM
Hello,
I think you need at least XE3.08:
"Beginning in Cisco IOS XE Release 3.8.0E and Cisco IOS Release 15.2(4)E, you can configure Policy-Based Routing (PBR) to use object tracking, to verify the most viable next-hop IP address to which to forward packets, using an Internet Control Message Protocol (ICMP) ping as the verification method."
09-03-2018 11:52 PM
Hello,
I think you need at least XE3.08:
"Beginning in Cisco IOS XE Release 3.8.0E and Cisco IOS Release 15.2(4)E, you can configure Policy-Based Routing (PBR) to use object tracking, to verify the most viable next-hop IP address to which to forward packets, using an Internet Control Message Protocol (ICMP) ping as the verification method."
09-04-2018 12:15 AM
I had missed that - thanks Georg! Time to schedule an outage and get this upgraded.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide