My new router (identical to an older one) does not allow me to configure mmi. Keeps returning the "invalid input" for mmi
Here is my sh ver
IVR-2801B#sh ver
Cisco IOS Software, 2801 Software (C2801-SPSERVICESK9-M), Version 12.4(15)T5, RELEASE SOFTWARE (fc4
)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Wed 30-Apr-08 15:20 by prod_rel_team
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
IVR-2801B uptime is 35 minutes
System returned to ROM by power-on
System image file is "flash:c2801-spservicesk9-mz.124-15.T5.bin"
...
...
...
Cisco 2801 (revision 7.0) with 118784K/12288K bytes of memory.
Processor board ID FTX1203Z041
2 FastEthernet interfaces
24 Serial interfaces
1 Channelized T1/PRI port
2 DSPs, 24 Voice resources
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
125440K bytes of ATA CompactFlash (Read/Write)
....
