Hello, I manage a network consists of 29 cisco catalyst platform 4507, 2960, 2950, under a VTP domain, is being implemented voice over IP and I have problems with the network to be set up for that purpose. The solution is the manufacturer for ericsso...
on the 6748 blade, one port only connect to a gig port microsoft server, I want to set the speed at 100kbps...yes, you heard right 100kbps. Can I use any CatIOS Qos to do this? If not 100Kbps, what is the minimum bw?
I have a department in my network called D department. This D want to be isolated from the network but wants to use some facilities of the network such as email , ftp etc. But D does not want anyone else to be able to enter its PCs. So i put a layer ...
Dear All,When I use power calculator (www.cisco.com/go/powercalculator) to calculate the power supply needed for a 6500 (e.g. 6509E) switch. If I use a sup7203B with 4 x WS-X6748-GE-TX (with DFC3a), 1 x WS-X6704-10GE (with DFC3B) and 3 x WS-X6748-SFP...
Hi AllI am in the process of connecting a Netgear FSM726 to a Cisco Switch. When I do this, with auto/auto on the Switch end, it keeps coming up as err-disabled.I have done the following:1. Removed spantree portfast.2. Change the port to 100/Full3. M...
Hi all, on my cisco asa, if I want to clear an access list would i do clear configure access-list test etc? or can i do a no access-list test?are most commands no removed via the clear config command?
Can anyone tell me what software can recieve the qos statistics output data and display some useful information? I assume its something like ntop?Thanks
Hi everyone,Suppose that a router is connected to two switches(switch A and switch B).SwitchA is connected to 2 pcs and a server.SwitchB is connected to 1 pc and 1 server.When i didn't configure vlans on switches PDUs of pcs of switchA succesfully re...
Hi,I am planning to connect a edge switch direct to our core switch.What I have currently is a “primary core†and “secondary core†etherchannel together and both are configure with lower bridge priority (24577).My question are:1. If I have to...
Folks, I have a FR switch with is configured as full mesh. I have 3 routers connected as hub ann spoke. I have disabled inverse arp and point to only the hub at the spokes to reach each other, still when i type show frame relay PVC it shows me ...
I'm trying to break up a /24 subnet for one of my sites in order to create VLANs. I want to break up 192.168.100.0/24 like this:192.168.100.1/26 (for 62 hosts)192.168.100.65/25 (for 126 hosts)I know there are portions of the subnet left over but I d...
Hello,I got a strange issue with a trunking problem. I have a dedicated 100mb cross-connect between two co-location facilities.Here are the configs:Switch_2950: Int f0/1switchport access trunkswitchport mode nongegotiatespeed 100duplex fullno cdp ena...
