cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1198
Views
0
Helpful
9
Replies
Highlighted

Cat 4500 - dual SUP 7 - entservices license

Hi,

I just looked all ten ports on SUP in slots 5 and 6 and I can see that Ten 5/3, Ten 5/4, Ten 6/3 and Ten 6/4 are inactive. I am not sure why and is there some restriction or should I add to the configuration?

Thanks.

9 REPLIES 9
Highlighted
Hall of Fame Expert

Hi,

Are you sups configured for redundancy (SSO)?

what is the output of "sh redu"?

HTH

Highlighted

It is SSO

Highlighted

So, when connecting these 10Gig interfaces, do you see a link light?

Highlighted

No link light. Show interface command shows that ports are inactive. When I plug the same SFP and patch cable into Ten 5/1 or 5/2 it works. Only ports 5/3, 5/4, 6/3 and 6/4 are affected.

Highlighted

Just to add, software is IOS-XE 3.2.0

Highlighted

What is your license level?

Highlighted

entservices

Highlighted

from the config guide:

When you use WS-X45-SUP7-E in RPR or SSO mode,  only the first two uplinks on each supervisor engine are available. The  second two uplinks are unavailable.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/01xo/configuration/guide/RPR.html#wp1159040

Highlighted

Thanks.

I found that too, I was just not sure if there is anything that can be done to make them active

Content for Community-Ad