Hello
I will to connect a ForcePoint WebSense to CAT6500 with SUP-2T and IOS 15.5, searching information about the configuration I only found an old cisco documentation on 6500 with SUP 720 and older with IOS 12.x.
https://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/116134-config-wccp-6500-00.html#anc6
On newer IOS like 15.5, is it possible with L3 GRE to make the CPU process high?
Does anybody are configure WCCPv2 on 6500 with SUP-2T IOS15.5?
###Enable WCCP V2######
ip wccp version 2
ip wccp web-cache
###IP-Address ForcePoint WebSense###
ip access-list 10 permit host 172.16.X.X
###Redirect-List ACL to ForcePoint###
ip access-list 110 permit tcp 10.5.1.x 0.0.0.255 any eq 80
ip access-list 110 permit tcp 10.5.1.x 0.0.0.255 any eq 443
### WCCP### (web-cache=80)(70 = 443)
ip wccp web-cache group-list 10 redirect-list 110
ip wccp 70 group-list 10 redirect-list 110
###SVI USER###
interface vlan X
ip wccp web-cache redirect in
ip wccp 70 redirect in
Thank and regards