Cat6509E stuck in Rommon 1>

ney25 · ‎11-29-2008

Hi Netpro,

i am stuck in Rommon , my cat6 can not bootup. need your advice .

thanks.

regard

jack

ergonullu · ‎11-29-2008

Get a suitable IOS from Cisco and boot from tftp which could be your laptop

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00800949c3.shtml

vishwancc · ‎11-29-2008

Hi Jack,

Where you doing some thin when it got into rommon.

I assume it is running hybrid IOS ,so is it rommon of SP or RP.

Give configregister value 0x2102 and reset.

Chao

Vishwa

ney25 · ‎11-29-2008

Hi Vishwa,

this is sup 720 whereby someone itchy hand loaded wrong ios therefore causing switch cant boot up.

your reply will be highly appreciated.

thanks.

regards,

jack

viyuan700 · ‎11-29-2008

see if u dont have this file and can help u.

U can use the procedure to copy right image from xmodem.

ney25 · ‎12-01-2008

Hi Viyuan,

thanks for your doc. it was really helpful but i dont know why ? after new ios loaded and boot path have been setup as well. somehow when i reload , it's went back to Rommon 1> again. :(

your reply will be highly appreciated.

thanks.

jack

viyuan700 · ‎12-01-2008

Hi Jack,

Can u please post the message it gives u before Rommon1 prompt