Cat8500 Show ACL Commands

[AshSe]

I need to find the interface on which a particular ACL is applied. What is the show command for that?

[MHM Cisco World]

sh run | I interface|access-group

This command 

MHM

[AshSe]

ACL is applied as "access-class". Can you tell me what is the significance of "access-class <ACL name> in" command. And where is this ACL applied. As we know we use "access-group" command to apply ACL on an Interface.

[MHM Cisco World]

As I know access-class is use only for VTY line not for physical interface.

Are you sure this command apply under interface?

MHM

[balaji.bandi]

check in the VTY Lines configuration as example below :

access-list 10 permit 10.20.0.0 0.0.255.255
line x x
 access-class 10 in