Hi i paln to connect a blad to a Cisco 3550 and need to transfer the VLAN from Cisco to HP. I knwo HP do not support this can anyone give me a template to configure for the Cisco internface using the correct protocal i assum LACP?
Hi all, on my 3550 switch, I have several vlans, for the default gateway for management I have set this as the ip address of one of the vlan interfaces, is this correct ?
Hi i had an weird problem,one of my access Switch (4506) got restarted without any reason.When i check in logs it doesnot show me anything.Can any one help me what is the issue.Please find below config on my switch.cisco WS-C4507R (MPC8245):ROM: 12.2...
hi i am receiving the mentioned below error on my distribution switches which are connected to each other via fiber and bundled with etherchannel (Po1) the mac address are access switches spanning tree working fine and everything is fine as yet but t...
hi all,just some basic vtp questions..always a bit scary when connecting switches with each other..;)..When 2 switches are in different VTP domains will it effect each others configuration if better configuration revision number in one of those?When ...
Hello there!Please S.O.S.We have on our campus two 6509 connected together with a Gig link running hsrp. Master 10.1.16.4 Standby client 10.1.16.5 and vertual and default gateway for hosts 10.1.16.1I have a filling hsrp is no longer working.Problem 1...
hi every body!i was studying stp and one thing baffled me about bridge id.bridge id uses mac address and prioritybut which mac address is used for bridge id as a switch could have as many mac address as ports it could have ?any idea about this ?my s...
hi every body!I have few questions about etherchannel and stp.let say wehave two swithes : sw1 and sw2.sw1 and sw2 are connected by f0/1 and f0/2.Assuming stp and etherchannel configuration in place,which protocol acts first. If stp acts first, it wi...
Hi everyone,I have the question about the lithium battery on MSFC.Is there any command to display voltage of lithium battery to confirm whether the life of lithium battery is lost.I can not find related information on CCO.Your information would be ap...
Hi all My customer has been using Etherswitch module as layer two for their WAN links. I know there is a limitation for ESW where you can't applied the Service policy out to the fastethernet ports. so the only way we can do it is through the layer qu...
hi every body!I have this simple questionlet say we have three switches : sw1,sw2 and sw3.sw 1 is root switch. They are connected serially. c=1 c=1 (sw3) f0/2---- f0/2(sw2) f0/1-- f0/1 (sw1) where "c"...
