06-17-2015 10:02 AM - edited 03-08-2019 12:35 AM
Dear Colleagues
I must make new small core in the my network.
I will use catalyst 4500-x with uplink module.
I think, make port-channel with two ports in the each switch - one from the main module and one from the uplink module.
Also, I will use dedicated link for fast-hello.
is it good scheme?
Thank!
06-17-2015 10:31 AM
Hi Oleg,
Please find below link the best practise of implementing the cat 4500 VSs:-
https://supportforums.cisco.com/docs/DOC-29472#comment-16116
This does also have all the answer for your query.
HTH
Regards
Inayath
*Please do not forget to rate the usefull posts.
06-18-2015 06:03 AM
Thank!
But I can not find any informaion about "fast-hello"
02-09-2017 12:18 PM
Oleg, I also wanted to know about this, and stumbled upon a well-buried excerpt that, I think, answers the question for us. This particular section is describing PAgP, but based on the reasoning for avoiding fast-hello, I think this applies to LACP as well, because you would have the same considerations/problems described in the section.
Perform a Find operation in your browser for the recommendation: "a fast-hello configuration should be avoided in VSS deployment"
http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Campus/VSS30dg/campusVSS_DG/VSS-dg_ch2.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide