05-12-2021 11:17 PM
I am now working on Catalyst 9200L-24T-4G and 48T-4G switches.
When I tried to configure trunk ports, the option switchport encapsulation dot1q/isl doesn't exist.
Then I looked for data sheets and there isn't any mention about ISL, but only IEEE 802.1Q is.
Based on facts above I believe Catalyst 9200L switches does not support ISL, but I am still not sure about it.
Is there any way to confirm the switch does not support the feature or not being able to configure it means that the switch does not support ISL?
Thanks in advance.
Solved! Go to Solution.
05-12-2021 11:51 PM
Hello,
the 9200 switches definitely does not support ISL. ISL support has been retired a very long time ago (before 2008 as far as I recall), anything developed after that only supports dot1q.
05-12-2021 11:55 PM
>...
Although most older routers (routers running IOS 12.2 and earlier) support both ISL and dot1q, some switch models support only dot1q, such as the 2960, 2960-x, 3650, and 9200 series. Check with the version of IOS you are using to determine whether ISL or dot1q is supported
M.
05-12-2021 11:51 PM
Hello,
the 9200 switches definitely does not support ISL. ISL support has been retired a very long time ago (before 2008 as far as I recall), anything developed after that only supports dot1q.
05-13-2021 12:01 AM
Hello Georg,
I was not 100% sure but now I am.
Thanks for answering.
best regards.
Kei
05-12-2021 11:55 PM
>...
Although most older routers (routers running IOS 12.2 and earlier) support both ISL and dot1q, some switch models support only dot1q, such as the 2960, 2960-x, 3650, and 9200 series. Check with the version of IOS you are using to determine whether ISL or dot1q is supported
M.
05-13-2021 12:08 AM
Hello marce
Thanks to the reference you shared I can now 100% sure about it.
Thanks a lot for answering.
best regards.
Kei
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide