09-21-2009 11:04 PM - edited 03-06-2019 07:49 AM
I copied configuration from SUP1 and put it in SUP2 bootflash.
When I use command set boot auto-config bootflash:sup.cfg, it gives me following message.
Warning: file found but it is not a valid config file
Appreciate any suggestions.
Thanks!!
09-21-2009 11:37 PM
Pankaj,
Are you sure that you have your configuration stored on bootflash titled sup.cfg?
HTH,
Mark
09-22-2009 12:29 AM
Yes.
Directory of bootflash:/
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
1 .. ffffffff bc7dcdfa 102850c 26 16417932 Aug 14 2009 19:31:52 cat6000-sup2cvk9.8-6-4.bin
2 .. ffffffff f870e80a 1041e98 16 104715 Feb 02 2000 13:06:15 w2_sup_21Sep.cfg
3 .. 1 6aa1cb85 1044830 13 10520 Feb 02 2000 13:13:24 w2_sup_22.cfg
15448016 bytes available (16533552 bytes used)
6509-1> (enable) set boot auto-config bootflash:w2_sup_21Sep.cfg
Warning: file found but it is not a valid config file.
Thanks!!
09-22-2009 08:06 AM
one possibility is the problem of notepad ? the character-set is not recognized
how about change another text-editor and try again.
hope it help
Yang
09-22-2009 10:00 AM
It doesn't work even if I TFTP a file from another SUP to this SUP with no modification.
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide