CBS350 static route doesn't show on cli

[h1pp13p373]

Hey Y'all,

I'm configuring a new CBS350 and am just trying to add static routes via the command line, using the usb console.  I set the route, but 'show ip route' doesn't show it:

cisco-peach(config)#ip route 192.168.13.0 255.255.255.0 192.168.7.5 metric 2
cisco-peach(config)#exit
cisco-peach#show ip route
Maximum Parallel Paths: 1 (1 after reset)
IP Forwarding: enabled
Codes: > - best, C - connected, S - static


C   192.168.99.0/24 is directly connected, vlan 99                         
cisco-peach#

When I go to the gui, I can see the route.  (see image attached)

I'm a noob to the cli and would appreciate any advise.

Thanks!

[pman · Accepted solution]

Hi,

please post the config of the router.

you are pointing to next-hop of 192.168.7.5 for network 192.168.13.0 - 

In order for the static route to show in routing table the IP address to which you point as next-hop (192.168.7.5 in this case) should be in the same network as one of the interfaces of your router, that interface should be in up state.
I guess that's not the case right now?

https://www.cisco.com/c/en/us/support/docs/smb/switches/Cisco-Business-Switching/kmgmt-2257-configure-ipv4-static-routes-settings-on-a-switch-through-th.html

[h1pp13p373]

Thank You pman!!  I clicked on solved by mistake, but I do have that ip range on a vlan interface.

cisco-peach#show run
config-file-header
cisco-peach
v3.0.0.69 / RCBS3.0_930_770_008
CLI v1.0
file SSD indicator encrypted
@
ssd-control-start
ssd config
ssd file passphrase control unrestricted
no ssd file integrity control
ssd-control-end cb0a3fdb1f3a1af4e4430033719968c0
!
!
unit-type-control-start
unit-type unit 1 network gi uplink none
unit-type-control-end
!
vlan database
vlan 7,9,99
exit
voice vlan oui-table add 0001e3 Siemens_AG_phone
voice vlan oui-table add 00036b Cisco_phone
voice vlan oui-table add 00096e Avaya                 
voice vlan oui-table add 000fe2 H3C_Aolynk            
voice vlan oui-table add 0060b9 Philips_and_NEC_AG_phone
voice vlan oui-table add 00d01e Pingtel_phone         
voice vlan oui-table add 00e075 Polycom/Veritel_phone 
voice vlan oui-table add 00e0bb 3Com_phone            
disable ports leds                                    
ip dhcp server                                        
ip dhcp pool network 42                               
address low 192.168.42.100 high 192.168.42.254 255.255.255.0
exit                                                  
ip dhcp pool network mgmt                             
address low 192.168.99.100 high 192.168.99.254 255.255.255.0
domain-name lucky.org                                 
dns-server 1.1.1.1                                    
exit                                                  
bonjour interface range vlan 1                        
hostname cisco-peach                                  
username admin password encrypted <edited>
username hippie password encrypted <edited>
ip ssh password-auth                                  
ip ssh pubkey-auth auto-login                         
crypto key pubkey-chain ssh                           
user-key hippie-marg rsa                              
key-string row AAAAB3NzaC1yc2EAAAADAQABAAABAQDeuwwFfnEH
key-string row Ooctt7h+7eLyGlO8+wQP0e38Uu3Y5Y2hVhve6lw6
key-string row hxm/gdaH3h8uRiVGSt2tvo9SV1I+r61P0ivQqGbA
key-string row 8RINKcWqYYkrF0d1ZoiVM5NRVsArLFNo       
key-string row VDzjxcskJSPhtNMCDH6gbLM1ck8Vvhi7ftPBncSy
key-string row hvOpxTNGDgHFfvuK2nqyvjDPO7dR1ekvae35/tUZ
key-string row OLzcIeLgU2YUpKtwuFiLE2fZ1eB74cxsT8+9ZdiC
key-string row T0IDwfvk9YIBlr//jflZewIc1XoOAkclHw5Pxfcv
key-string row vbXOT97s0aqqdTT0TphhawMdaoCf2y0ZlV5OzYko
key-string row Uu56+byGnKczTVihWG3N                   
exit                                                  
user-key hippie-sterling rsa                          
key-string row AAAAB3NzaC1yc2EAAAABIwAAAQEA44qXiwkYCbzB
key-string row U7bXNmIqsYPDdK8Mad43k6bSmXu76pyZ2TVB1e0H
key-string row JkbCIzMUGg9gWDvehVo6tP0D7GDj3el8JVXZMz7c
key-string row vBg76F6ZXHT3MqPfdgINx8nwlz5Kxglt       
key-string row aFuhWBtQ5aVolO+8BXGdxAV3rr485WUuvnwLxwWt
key-string row fYUzywXpMk2parTzXBrJszafCKMLDYlVXozWraiV
key-string row 0vs4Wvetfr/f6zd0CiclC/FSPwSQbf208kv+Fz1B
key-string row OHrLjQ4AwcbBXnZy3sB/u+SKQaCuawI11AL6K6nN
key-string row BUw08mApdFixEs8BkgI7MHldUc8hR56uD/vKsRPe
key-string row 7G1iaBaUS/9oryKSnQ==                   
exit                                                  
exit                                                  
snmp-server location parlor                           
snmp-server contact hippiepete                        
clock timezone EST -4                                 
clock summer-time web recurring usa                   
sntp server 192.168.42.1                              
clock dhcp timezone                                   
!                                                     
interface vlan 1                                      
 ip address 192.168.42.10 255.255.255.0               
 no ip address dhcp                                   
!                                                     
interface vlan 7                                      
 name trusted                                         
 ip address 192.168.7.4 255.255.255.0                 
!                                                     
interface vlan 9                                      
 name voip                                            
!                                                     
interface vlan 99                                     
 name mgmt                                            
 ip address 192.168.99.1 255.255.255.0                
!                                                     
interface GigabitEthernet2                            
 switchport access vlan 7                             
!                                                     
interface GigabitEthernet9                            
 switchport access vlan 99                            
!                                                     
interface GigabitEthernet10                           
 switchport access vlan 9                             
!                                                     
exit                                                  
banner login ^C                                       
This is the Dude's network, please abide appropriately.
^C                                                    
ip route 192.168.13.0 /24 192.168.7.5 metric 2 

[pman]

please post output of "show ip interface" and "show interfaces status"

please add "ip routing" command: switch(config)# ip routing

[h1pp13p373]

I had set 'ip routing', but set it again.  Here is the output.

cisco-peach#show ip int


    IP Address        I/F    I/F Status  Type   Directed  Prec Redirect Status 
                             admin/oper         Broadcast                      
------------------ --------- ---------- ------- --------- ---- -------- ------ 
192.168.7.4/24     vlan 7    UP/DOWN    Static  disable   No   enable   Valid  
192.168.42.10/24   vlan 1    UP/DOWN    Static  disable   No   enable   Valid  
192.168.99.1/24    vlan 99   UP/DOWN    Static  disable   No   enable   Valid  

cisco-peach#show int status
                                             Flow Link          Back   Mdix
Port     Type         Duplex  Speed Neg      ctrl State       Pressure Mode
-------- ------------ ------  ----- -------- ---- ----------- -------- -------
gi1      1G-Copper      --      --     --     --  Down           --     --    
gi2      1G-Copper      --      --     --     --  Down           --     --    
gi3      1G-Copper      --      --     --     --  Down           --     --    
gi4      1G-Copper      --      --     --     --  Down           --     --    
gi5      1G-Copper      --      --     --     --  Down           --     --    
gi6      1G-Copper      --      --     --     --  Down           --     --    
gi7      1G-Copper      --      --     --     --  Down           --     --    
gi8      1G-Copper      --      --     --     --  Down           --     --    
gi9      1G-Combo-C     --      --     --     --  Down           --     --    
gi10     1G-Combo-C     --      --     --     --  Down           --     --    

                                          Flow    Link        
Ch       Type    Duplex  Speed  Neg      control  State       
-------- ------- ------  -----  -------- -------  ----------- 
Po1         --     --      --      --       --    Not Present 
Po2         --     --      --      --       --    Not Present 
Po3         --     --      --      --       --    Not Present 
Po4         --     --      --      --       --    Not Present 
Po5         --     --      --      --       --    Not Present 
Po6         --     --      --      --       --    Not Present 
Po7         --     --      --      --       --    Not Present 
Po8         --     --      --      --       --    Not Present 

[pman · Accepted solution]

it's looks like interface vlan is down because gi2 is down?

192.168.7.4/24     vlan 7    UP/DOWN    Static  disable   No   enable   Valid  

                                             Flow Link          Back   Mdix
Port     Type         Duplex  Speed Neg      ctrl State       Pressure Mode
-------- ------------ ------  ----- -------- ---- ----------- -------- -------
gi1      1G-Copper      --      --     --     --  Down           --     --    
gi2      1G-Copper      --      --     --     --  Down           --     --    

from your config:

interface vlan 7                                      
 name trusted                                         
 ip address 192.168.7.4 255.255.255.0                          
!                                                     
interface GigabitEthernet2                            
 switchport access vlan 7                             
!                                         
ip route 192.168.13.0 /24 192.168.7.5 metric 2 

[h1pp13p373]

All interfaces are down because I'm accessing via the usb console.  Does an interface with an associated ip have to be plugged in to set static routes?  Or would I need to bring it up from cli?

[pman]

As I mentioned above, the interface should be in the status up (gi2 in this case) from your output we can see that Link Status is Down (Link State = Down for Gi2)

Is a network cable currently connected to Port Gi2?

[h1pp13p373]

Ok, I plugged my laptop into gi2 and can see the route now!  So, I guess the 'show ip route' command only shows routes that are active... but the gui showed it either way?

cisco-peach#19-Nov-2021 17:17:11 %LINK-I-Up:  gi2
19-Nov-2021 17:17:11 %LINK-I-Up:  Vlan 7

cisco-peach#shi19-Nov-2021 17:17:15 %STP-W-PORTSTATUS: gi2: STP status Forwarding
 
cisco-peach#show ip route
Maximum Parallel Paths: 1 (1 after reset)
IP Forwarding: enabled
Codes: > - best, C - connected, S - static


C   192.168.7.0/24 is directly connected, vlan 7                           
S   192.168.13.0/24 [1/2] via 192.168.7.5, 03:21:35, vlan 7 

[h1pp13p373]

Now I'm cooking with grease.     I unplugged, then added 'static' to my command and voila!  There's the route. Just the learning curve of a noob.   Thanks tons pman!!

cisco-peach#show ip route static
Maximum Parallel Paths: 1 (1 after reset)
IP Forwarding: enabled

Codes: A - active, I - inactive

I  192.168.13.0/24 [1/2] via 192.168.7.5 

[pman]

Excellent!
I was glad to help!