Hi everyone,
i have cisco 2821 router. i am facing booting problem.
anybody suggest me what is the problem.
thanks in advance......
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
Initializing memory for ECC
.
c2821 platform with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Readonly ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0x26bc2cc
Self decompressing the image : #################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################# [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
0003E8 0X003DA000 C2821 Mainboard
0001AB 0X0025178C 1A E3
0X00263F50 Onboard VPN
0X000021B8 Onboard USB
0X002C29F0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X00D65284
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 14Mb.
Using 5 percent iomem. [14Mb/256Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(9)T7
, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Thu 10-Jan-08 16:35 by prod_rel_team
Image text-base: 0x400B1E74, data-base: 0x434A9AC0
****** ERROR detected on PCI1 Bus
****** Try RESEATING all modules in the system
****** pci1_int_cause 0x00000240,
****** pci1_err_addr 0x00091009, pci0_err_cmd 0x0000000A
****** PCI Master Read Parity Error
PCI Target Abort
r0 = FFFFFFFF r1 = FFFFFFFF r2 = 0 r3 = 45C80000 r4 = 0
r5 = 303 r6 = 0 r7 = 1 r8 = 0 r9 = 100000
r10 = 0 r11 = 465E4369 r12 = 0 r13 = 465E436A r14 = 0
r15 = 8 r16 = 0 r17 = C100 r18 = 0 r19 = 3400C101
r20 = 0 r21 = 40096828 r22 = FFFFFFFF r23 = FFFF00FF r24 = 0
r25 = 469AAC64 r26 = 0 r27 = 469AAC60 r28 = 0 r29 = 469AAC5C
r30 = 0 r31 = 469AAC58 r32 = FFFFFFFF r33 = FFFFFFFF r34 = FFFFFFFF
r35 = FFFFFFFF r36 = FFFFFFFF r37 = FFFFFFFF r38 = FFFFFFFF r39 = FFFFFFFF
r40 = FFFFFFFF r41 = FFFFFFFF r42 = FFFFFFFF r43 = FFFFFFFF r44 = FFFFFFFF
r45 = FFFFFFFF r46 = FFFFFFFF r47 = FFFFFFFF r48 = 0 r49 = 469AACD0
r50 = 0 r51 = 0 r52 = 0 r53 = 3040A801 r54 = FFFFFFFF
r55 = A000F000 r56 = FFFFFFFF r57 = FFFFFFFF r58 = 0 r59 = 465E4358
r60 = FFFFFFFF r61 = FFFFFFFF r62 = 0 r63 = 402E4B10
sreg = 3400C103 mdlo_hi = 0 mdlo = 251C00
mdhi_hi = 0 mdhi = 0 badvaddr_hi = FFFFFFFF
badvaddr = FFFFFFFF cause = FFFFFFFF epc_hi = 0
epc = 402E4B08 err_epc_hi = FFFFFFFF err_epc = FFFFFFFF
%ERR-1-FATAL: Fatal error interrupt, reloading
err_stat=0x0
=== Flushing messages (02:37:51 UTC Wed May 18 2016) ===
Queued messages:
02:37:51 UTC Wed May 18 2016: Interrupt exception, CPU signal 22, PC = 0x0
--------------------------------------------------------------------
Possible software fault. Upon reccurence, please collect
crashinfo, "show tech" and contact Cisco Technical Support.
--------------------------------------------------------------------
-Traceback=
$0 : 00000000, AT : 00000000, v0 : 00000000, v1 : 00000000
a0 : 00000000, a1 : 00000000, a2 : 00000000, a3 : 00000000
t0 : 00000000, t1 : 00000000, t2 : 00000000, t3 : 00000000
t4 : 00000000, t5 : 00000000, t6 : 00000000, t7 : 00000000
s0 : 00000000, s1 : 00000000, s2 : 00000000, s3 : 00000000
s4 : 00000000, s5 : 00000000, s6 : 00000000, s7 : 00000000
t8 : 00000000, t9 : 00000000, k0 : 00000000, k1 : 00000000
gp : 00000000, sp : 00000000, s8 : 00000000, ra : 00000000
EPC : 00000000, ErrorEPC : 00000000, SREG : 00000000
MDLO : 00000000, MDHI : 00000000, BadVaddr : 00000000
CacheErr : 00000000, DErrAddr0 : 00000000, DErrAddr1 : 00000000
DATA_START : 0x434A9AC0
Cause 00000000 (Code 0x0): Interrupt exception
Writing crashinfo to flash:crashinfo_20160518-023752
No warm reboot Storage
*** System received a System Error ***
signal= 0x16, code= 0x0, context= 0x46905718
PC = 0x40096d7c, Cause = 0x20, Status Reg = 0x34008002
