CPU utilization for five seconds: 8%, one minute: 8%, five minutes: 8%
Core 0: CPU utilization for five seconds: 7%, one minute: 7%, five minutes: 8%
Core 1: CPU utilization for five seconds: 6%, one minute: 8%, five minutes: 8%
Core 2: CPU utilization for five seconds: 6%, one minute: 9%, five minutes: 8%
Core 3: CPU utilization for five seconds: 10%, one minute: 8%, five minutes: 9%
Core 4: CPU utilization for five seconds: 11%, one minute: 8%, five minutes: 8%
Core 5: CPU utilization for five seconds: 6%, one minute: 6%, five minutes: 8%
Pid PPid 5Sec 1Min 5Min Status Size Name
--------------------------------------------------------------------------------
13308 12822 41% 40% 40% S 2182856704 fed main event
12859 9030 7% 8% 9% S 2177421312 linux_iosd-imag
(Oooops. Me bad. I forgot to mention to post only the "first page". My apologies.)
Top bit tells me the each CPU are working normally. No CPU is running "hot" (or as TAC want to call it, "hot spinning").
Bottom bit tells me the CPU is mostly being used by the process called "fed" (forwarding engine driver) and to be honest, 40% isn't high.
Do you have IPv6 running?
One last thing: Make sure to run the command
show processes cpu platform sorted location switch <all switch members> r0
on all switch members and compare the "first page" to the master. Same thing as I've mentioned above:
- Any of the individual cores running "hot"? (60% and above is a "worry", 80% and above is BAD.)
- Any processing other than the one found in the master hogging the CPU?
Those are the things to watch out.
NOTE: The command "sh proc cpu cpu" does not "apply" to switches running 16.X.X (and later). The command above is the new "norm".
