03-06-2018 06:59 AM - edited 03-08-2019 02:08 PM
Greetings,
On past cisco platforms, say c2950,2960x, I have used xmodem to upload config-files to running-config. Much easier than to use just copy and paste. Thats so 90s.
But on the c3850 platform, xmodem does not exist.
copy xmodem: running-config
Does anybody know how to accomplish something similar with the c3850?
Regards
Solved! Go to Solution.
08-13-2018 04:28 AM
Hi Ronny.
On the 3850-platform there is no way to copy config through the console.
You have to use another way to solve it by copying through another interface. (USB/TFTP/FTP/SCP/RCP/HTTP/HTTPS)
BR
Espen.
03-06-2018 07:06 AM
Why wouldn't you use TFTP or FTP? Xmodem is very slow.
Mike
03-06-2018 07:13 AM
03-06-2018 07:25 AM
I found the below about password recovery. I am wondering if you need to do this to enable Xmodem?
Reconnect the power cord to the or the active switch. Within 15 seconds, press the Mode button while the System LED is still flashing green. Continue pressing the Mode button until all the system LEDs turn on and remain solid; then release the Mode button.
03-06-2018 07:37 AM
03-06-2018 12:20 PM
03-06-2018 11:17 PM
03-07-2018 06:28 AM
I forgot about the USB, great catch Leo! That is why you are the man! :-)
03-07-2018 11:11 PM
08-13-2018 04:28 AM
Hi Ronny.
On the 3850-platform there is no way to copy config through the console.
You have to use another way to solve it by copying through another interface. (USB/TFTP/FTP/SCP/RCP/HTTP/HTTPS)
BR
Espen.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide