07-21-2012 05:12 PM - edited 03-07-2019 07:54 AM
Hello All,
Can someone verify if this config-register value shown means that the switch will boot up and use the start-up configuration or not?
NUSWRNAS004#sh bootvar
BOOT variable = bootflash:cat4500e-ipbasek9-mz.122-53.SG4.bin,1;
CONFIG_FILE variable does not exist
BOOTLDR variable does not exist
Configuration register is 0x2
Adil
07-21-2012 05:15 PM
Hi,
Should be 0x2102
HTH
07-21-2012 05:20 PM
Reza,
This value of 0x2 was the default value. What is the impact if I kept at the default and rebooted the switch after upgrading the IOS?
Adil
07-21-2012 08:13 PM
Hi Adil,
There should be no impact. As long as it is 0x2 and not any other number, the switch will boot based on your boot system command.
If it is 0x2 (default) and the switch booted fine the first time, than you should be fine.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: