08-29-2017 11:36 AM - edited 03-08-2019 11:52 AM
I have created a new VDC on my 7710 however when i try to allocate 8 ports to the VDC the switch is indicating i need to allocate 24 ports for the port-group. Is this correct for the N77-M348XP-23L line card?
allocate interface Ethernet2/1-7
Entire port-group is not present in the command. Missing ports will be included automatically
Additional Interfaces Included are :
Ethernet2/8
Ethernet2/9
Ethernet2/10
Ethernet2/11
Ethernet2/12
Ethernet2/13
Ethernet2/14
Ethernet2/15
Ethernet2/16
Ethernet2/17
Ethernet2/18
Ethernet2/19
Ethernet2/20
Ethernet2/21
Ethernet2/22
Ethernet2/23
Ethernet2/24
Moving ports will cause all config associated to them in source vdc to be removed. Are you sure you want to move the ports (y/n)?
08-29-2017 11:51 AM
Have a look at this link and see table-1 for port group numbering
HTH
08-29-2017 12:11 PM
Thank you i reviewed the document but it seems to be for the 7k, my devices are 7710. Even if i try to allocate a single interface it still indicates 24 ports are in the port-group. `
08-29-2017 12:37 PM
Hi,
Can you try 1,3, 5,7 or 2,4,6,8
HTH
11-29-2018 10:25 AM
See the below info. You will need to allocate them in ports of 24 with the linecard you have.
The Cisco Nexus 7700 Series M3 Ethernet modules have the following number of port groups and interfaces. VDC allocation is based on port group boundaries.
N77-M312CQ-26L—Has six ASICs, 6 port groups of 2x100G ASIC
N77-M324FQ-25L—Has four ASICs, 4 port groups of 6x40G ASIC.
N77-M348XP-23L—Has two ASICs, 2 port groups of 24x10G ASIC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide