cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
389
Views
0
Helpful
7
Replies
Beginner

Cisco 800M Series Router, not connecting WAN

Hi

i have a just bought a Cisco 800M Series router, i have a Leased line with Static ip. i want to connect my WAN through the static ip but it is not connecting. also where to enter the gateway of leased line.

Please help me. how to connect it through Static ip

Thanks in advance.

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Hello,

Hello,

post the config you have so far.

What is your WAN connection, the GigabitEthernet, the serial interface ?

View solution in original post

7 REPLIES 7
Highlighted
VIP Mentor

Hello,

Hello,

post the config you have so far.

What is your WAN connection, the GigabitEthernet, the serial interface ?

View solution in original post

Highlighted
Beginner

Static IP settings

Static IP settings

ip Address 117.240.94.19

Subnet mask 255.255.255.248

default gateway 117.240.94.17

i am using its Quick Setup.

GigabitEthernet.

Highlighted
VIP Mentor

Hello,

Hello,

make sure you are on the right interface. The GigabitEthernet WAN Interfaces are
0/8 and 0/9 for the Cisco C841M-8X ISR, and 0/4 to 0/5 for the Cisco C841M-4X

The config would look like this:

interface GigabitEthernet0/8
 ip address 117.240.94.19 255.255.255.248

The default route would be:

ip route 0.0.0.0 0.0.0.0 117.240.94.17

Highlighted
Beginner

its Cisco C841M-4X

its Cisco C841M-4X

but i didnt get you.

can u tell me step be step configuration ?

Highlighted
VIP Mentor

Hello,

Hello,

have a look at the link below. This is all done from the command line.

Configuring Gigabit Ethernet WAN Interfaces

http://www.cisco.com/c/en/us/td/docs/routers/access/800M/software/800MSCG/routconf.html#59429

Highlighted
Beginner

How to do without command

How to do without command prompt through Cisco Configuration Professional link i.e. 10.10.10.1 

Please guide.

otherwise how to go to command line ?

Highlighted
VIP Mentor

Hello,

Hello,

go to Chapter 5 of the attached guide, it has detailed instructions on how to configure the WAN Ethernet interfaces:

http://www.cisco.com/c/dam/en/us/td/docs/net_mgmt/cisco_configuration_professional/v2_5/olh/ccp.pdf

CreatePlease to create content
Content for Community-Ad