Cisco 9300 Stack Power Cabling

[dm2020]

Hi All,

Hopefully just a quick question - I'm looking to connect 4 x Cisco Cat9300 in a stack-power ring (no XPS) and I cant find any Cisco documentation that confirms how the ring should be formed, specifically which colour (yellow or green) of the stackpower cable should be connected to which stackpower port on the back of the Cat9300 switch. Is there a specific way that these should be connected or does it not matter?

Thank you

[Reza Sharifi · Accepted solution]

Hi,

Have a look at this document and look for figure-9 and 10.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/hardware/install/b_c9300_hig/b_c9300_hig_chapter_010.html

HTH