cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
629
Views
0
Helpful
5
Replies
hjacquemin
Beginner

Cisco 9600 upgrade

Hello,

 

We just received our new Cisco 9600 swtiches and I tried to upgarde them the version 17.2.1.

 

I followed the procedure from this Release Note

 

Everything seems to work fine except from point number 5.

 

Step 5 	

upgrade rom-monitor capsule golden switch

Use this command to upgrade the ROMMON version. After you enter the command, confirm upgrade at the system prompt.

For more information about this, see ROMMON Upgrades, in this document.

Switch# upgrade rom-monitor capsule golden switch active R0 
This operation will reload the switch and take a few minutes to complete. Do you want to proceed (y/n)? [confirm]y
Switch#
Initializing Hardware...
output truncated

The command "upgrade rom-monitor capsule golden switch active R0" is not available., Catalyst 9000

If I do a show ver/show module the version is well 17.2.1 except for the Fw column from "show module" it's still 17.1.1.

I supposed I have to run the previous command to upgrade the Fw (rom-mon ?). If yes what's command will do the job as the one from the procedure is not available.

 

For information we are using 2 supervisor in the switches and at the moment the switch is simply running alone without network connection (so no stackwise at the moment).

 

Thanks for your help.

 

Regards,

 

HJacquemin

5 REPLIES 5
marce1000
VIP Mentor

 

 

 Sorry here goes again : Perhaps you can try command completion suggestion such as upgrade rom-monitor ?

M.