12-10-2015 01:15 PM - edited 03-08-2019 03:04 AM
I can't find anything stating that this isn't supported, but I'm unable to enable BFD on my tenG interfaces, which are online and routing. Does anyone know if this is supported?
The error I receive:
ASR1002X-02(config-router)#bfd interface ten0/2/0
%EIGRP: TenGigabitEthernet0/2/0 is not supported by BFD
Cisco IOS XE Software, Version 03.16.01a.S - Extended Support Release
Cisco IOS Software, ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.5(3)S1a, RELEASE SOFTWARE (fc1)
License Level: ipbase
XFP is SPA-1X10GE-L-V2
-TIA-
(I realize the error says it's not supported, but all of the documentation I can find says this should be supported)
12-10-2015 02:20 PM
This is an example off an interface I have (it has single mode fibre attached to it) on an ASR1004.
interface TenGigabitEthernet0/1/0
bfd interval 50 min_rx 50 multiplier 5
12-10-2015 04:03 PM
Looks like it's not supported in IP Base...that's my problem.
Thanks...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: