02-23-2015 07:25 AM - edited 03-07-2019 10:47 PM
Hi all,
I have a problem and I really do not know the reason.
Simple scenario. I need to configure ospf into a ASR1004 router.
Here the command
vrf definition TEST-02
!
address-family ipv4
exit-address-family
!
!
interface Loopback25
description TEST-02
vrf forwarding TEST-02
ip address 1.1.1.1 255.255.255.255
ip ospf 2 area 0.0.0.1
As soon I am running the command ip ospf 2 area 0.0.0.1, I got this error %VRF specified does not match existing router.
I configure with success other different vrf before and after this problem so I can not understand why the router is refusing this configuration.
Any idea?
Thank you.
Regards,
Fabio.
02-24-2015 11:59 AM
Hello.
Your OSPF process 2 (in global configuration mode) should be configured with vrf keyword like following:
router ospf 2 vrf TEST-02
02-24-2020 05:06 PM - edited 02-24-2020 05:10 PM
I know this is years later but I seen this asked many times and only answered with a solution by Vasilii Mikhailovskii
or you could remove existing running ospf 2 process in global configuration, then add it under the interface as you have it.
11-30-2021 01:10 PM
Another simple solution that worked for me, is reloading the router and tried the command again
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: