Hi Everybody!
I bought a AS2511RJ for my lab and a BL50R transceiver to allow my 2511 to access the LAN.
Now when I plug it with a Cat5e straight through cable from router A and configure a IP address on Ethernet0. I can see its receiving, but not sending. On the other side of the cable I have specified 10Mb/Half Duplex on the sending interface.
I have read the manual and can not find any information that may assist.
http://docstore.mik.ua/univercd/cc/td/doc/product/access/ap/ap_ts2/transc.pdf
Its has pretty lights on it that show it has a "link" and "Pwr" and sometimes "Rec" flashes to indicate it is taking traffic. But never send.
and a 'sh interface' shows
Ethernet0 is up, line protocol is down
Hardware is Lance, address is 0050.5480.605b (bia 0050.5480.605b)
Internet address is 172.16.99.253/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 128/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:09, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
139 packets output, 9096 bytes, 0 underruns
139 output errors, 0 collisions, 7 interface resets
0 babbles, 0 late collision, 0 deferred
140 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
is the AUI or transceiver faulty?
has any one seen this before?
Many thanks for any info.
Andy
