cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
842
Views
0
Helpful
1
Replies

Cisco Broadcast & Multicast Storm Control

balbeer.singh84
Beginner
Beginner

Hi,

I am going to configure the storm control in the switches & I am using the below commands :

//

interface <interface-list>

storm-control broadcast level 30.00

storm-control multicast level pps 5 3

//

I am applying this for all the access ports of the switches which are connecting to end users.

Please suggest whether I should apply this to uplink (trunk) ports of teh switches as well or not? If yes then what should be the limit on uplink (trunk) ports?

Please suggest.

-Balbeer

1 Reply 1

singhaam007
Participant
Participant

hello Balbeer,

you can use storm control config to control broadcast traffic.

Check this link for detail config

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22ea/SCG/swtrafc.html#wp1063295

hope fully this will help.

thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: