cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
412
Views
0
Helpful
2
Replies

Cisco-c3850-12x48u auto config power inline never. when switch is poweroff or reload.

Hi all,
I have problems when reloading switch or loss of power.
the switch has auto config command. the problem is a "Power inline nerver "


example before reload switch
"interface TenGigabitEthernet1/0/41
switchport access vlan 4
switchport mode access
"


example after reload switch
"interface TenGigabitEthernet1/0/41
switchport access vlan 4
switchport mode access
no mvrp timer periodic
no mvrp
power inline never
power inline police
power inline four-pair forced
snmp trap mac-notification change added
snmp trap mac-notification change removed
hold-queue 40 out
exit "



2 Replies 2

Francesco Molino
VIP Alumni
VIP Alumni
Hi

Can you give the output of: show power inline police

What's connected in this port?

Can you try:
- shut the port
- configure power inline auto
- no shut
- relod


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question

Leo Laohoo
Hall of Fame
Hall of Fame
Upgrade the firmware to 16.3.6 or 16.6.3.
Review Cisco Networking for a $25 gift card